Support Board
Date/Time: Tue, 09 Sep 2025 18:37:52 +0000
Post From: Prix ouverture/fermeture ETH ete RTH
| [2025-08-05 21:14:33] |
| John - SC Support - Posts: 41698 |
|
The general answer is that you should use the "High/Low for Time Period - Extended" study. You will need 4 copies of this for each symbol in order to capture the Open of the ETH, the Close of the ETH, the Open of the RTH, and the Close of the RTH. For this study, you will set the "Start Time" and "End Time" to the start and end of the bar that contains the particular item you want. For instance, if you are using 5 minute bars and the ETH starts at 17:00:00, then you would enter the following: - Start Time: 17:00:00 - End Time: 17:01:59 You would set the "Input Data High" to be the particular item for that specific instance of the study. So to continue with the above example, you are wanting the open for the ETH, so set the "Input Data High" to be "Open". Then on the Subgraphs set the "Low" subgraph Draw Style to "Ignore". For each item you can then extend the line as you want through that study. If you want the line extended more than what it does, you would need to use the "Spreadsheet Study" to copy the line value through to the times where you want the line displayed. Refer to the following: High/Low for Time Period - Extended Chart Studies: Ignore (ACSIL: DRAWSTYLE_IGNORE) For the most reliable, advanced, and zero cost futures order routing, use the Teton service: Sierra Chart Teton Futures Order Routing |